Pre Action Sprinkler System Diagram
Pre action sprinkler system diagram. The system is shown ready for operation. See full size image. Pre-action Systems are used to protect areas where water damage from damaged sprinklers or piping must be avoided.
Preaction fire sprinkler systems are best used in locations where accidental activation resulting in water damage could be costly ie. When the smoke detector gets activated cross zoned the smoke detector sends a signal to the pre-action control panel. The positive latching system uses the supply water pressure to hold the clapper shut.
In normal condition preaction system does not contain water in the sprinkler piping. Preaction System is also effectively used to have Pre-alarm of a possible fire condition and allows time to extinguish fire by hand held fire extinguishing equipment prior to water discharge through sprinkler heads. Valve operation is controlled by independent flame heat or smoke detection.
It presents the elements of the circuit as sleek forms and likewise the energy as well as sign hyperlinks in between the devices. The basic components of a Viking preaction system include a Model E or F series deluge valve and conventional. A supplemental detection system release line is installed in the same area as the sprinklers.
Sprinklers or damaged sprinkler piping. PREACTION SPRINKLER SYSTEM PREACTION-PAC With Compressor UFS-127 Rev 100 Page 3 of 15 4. Pre-action fire sprinkler systems employ the basic concept of a dry pipe system in that water is not normally contained within the pipes.
This system utilizes a Deluge Valve H3 and Riser Check Valve Model CH. Activation of a fire detector will open the pre -action valve allowing. Contractor is responsible for system layout in the fire zones indicated as Pre-Action on the contract drawings including spacing and location of sprinkler.
A fire will be sensed by a separate fire detection system usually a smoke detector. This system requires two events to happen before any sprinklers discharge.
Pre-Action fire sprinkler system uses concept of having dry pipe sprinkler system.
The functional test sequence oft he double interlock Automatic pre action system is as follows. Fixed fire protection systems with CLOSED sprinklers connected to piping pressurized with air or nitrogen with a dependable water supply controlled by a normally closed Deluge Valve activated by a release system. To simplify the process Viking also offers several factory assembled options. Pre-action pipes start out as dry pipes. Pre-action fire sprinklers fall right in between all of these. They are designed for applications such as refrigerated areas that require maximum protection against inadvertent operation of the sprinkler system. Valve operation is controlled by independent flame heat or smoke detection. It consists of shell and soldered brass cap. These systems require a preliminary actiona preactionbefore water discharges.
Pre-action fire sprinkler systems employ the basic concept of a dry pipe system in that water is not normally contained within the pipes. The positive latching system uses the supply water pressure to hold the clapper shut. 1-12 40 mm Download Bulletin. The pre-action sprinkler system is similar to the deluge sprinkler system except that the sprinklers are not open. Pre-action fire sprinklers fall right in between all of these. Parts Diagram Compare this exceptional walking sprinkler system with the average lawn sprinkler. When it is sensible and desirable to prevent any single source of damage from causing costly unwanted water discharge the preaction fire sprinkler system is the answer.
Post a Comment for "Pre Action Sprinkler System Diagram"